●
Do not clean the internal and external electrical components of the cabinet with water or detergent.
●
Do not stand, lean or sit on the device.
●
Do not damage any modules of the device.
2.2.4 Personnel Requirements
●
The personnel in charge of installation and maintenance must be strictly trained to understand all safety precautions
and master proper operation methods.
●
Only qualified professionals or trained personnel are allowed to install, operate and maintain the device.
●
The personnel who operate the device, including the operators, trained personnel and professionals, must have
special operation qualifications required by the local country, such as high voltage operation, working high above
the ground, and special equipment operation qualification.
●
The replacement of device or components (including software) must be carried out by professionals or authorized
personnel.
2.3 Electrical Safety
2.3.1 General Requirements
Before carrying out electrical connections, ensure that the device is not damaged,
or an electric shock or fire may occur.
Never install or remove any power cables when the power is on. The electric arcs or sparks
may be generated at the moment when the power cable contacts with the conductor, which
may cause fire or personal injuries.
●
All the electrical connections must meet the electrical standards of the country/region where the project islocated.
●
The cables prepared by users themselves shall comply with local laws and regulations.
●
Special insulating tools should be used in high-voltage operations.
●
Before connecting the power cord, ensure that the label identification on the power cord iscorrect.
●
Operations on the device are allowed only five minutes after the device is completely powered off.
●
The insulation layer of the cable may be aged or damaged when the cable is used in a high temperature environment.
Therefore, the distance between the cable and the heat source must be at least 30mm.
●
Cables of the same type should be bundled together. Whereas, the cables of different types should be routed at least
30mm apart, and shall not be wrapped together or crossed.
To Next Page
Loading...