The battery terminal components shall not be affected during transportation. And, the battery terminal bolts
shall not be lifted or transported.
It is strictly prohibited to alter, damage or block the marks and nameplates on the device.
The composition and working principle of the entire photovoltaic power generation system, as well as the
relevant standards of the country/region where the project is located shall be known fully.
After the device is installed, the empty packing materials, such as cartons, foam, plastics, and cable ties,
shall be removed from the device area.
2.2.3 Personnel Safety
●
When operating the device, appropriate personal protective equipment shall be worn. If any fault that may lead to
personal injury or damage of the device is found, immediately terminate the operation, report to the responsible
person, and take effective protective measures.
●
Before using any tools, learn the correct method of using the tool to avoid injuries and damage of the device.
●
When the device is running, the temperature of the case is high, which may cause burns. Therefore, do not touch the
case.
●
In order to ensure personal safety and normal use, reliable grounding should be carried out before use.
●
Do not open or damage the battery. The electrolyte released is harmful to skin and eyes, so avoid touch it.
●
Do not place irrelevant items on the top of the device or insert them into any part of the device.
●
Do not place flammable items around the device.
●
Never place the battery in the fire to avoid explosion and prevent the personal safety from being endangered.
●
Do not place the battery module in water or other liquids.
●
Do not short-circuit the battery terminals, because short-circuiting of the battery may cause combustion.
●
The battery may pose a risk of causing electric shocks and large short-circuit currents. When using the battery, the
following precautions should be paid attention to:
a)
The metal objects, such as watch and rings, shall be removed.
b)
Tools with insulated handles should be used.
c)
Rubber gloves and shoes should be worn.
d)
The charging power supply shall be disconnected before connecting or disconnecting terminals of the battery.
e)
Check whether the battery is accidentally grounded. If the battery is accidentally grounded, remove the power
supply from the ground.
To Next Page
Loading...