8
REPLACING THE STYLUS
CAUTION! Ensure the turntable is powered
OFF before replacing the stylus. Do not bend
the stylus or touch the needle, as this may
cause injury.
1. To remove the old stylus, carefully
place a screwdriver at the tip of the
stylus and push downward.
2. Remove the old stylus by gently pulling
it down and forward simultaneously.
3. To install the new stylus, hold the
stylus at the front edge (needle side)
and insert the rear edge into the tone
arm. (GUIDE PIN INSIDE)
4. Push the stylus upward until it locks
into position. Refer to C on the gure
above.
To Next Page
Loading...
