Akai MPC - Page 98

98
Phaser 1
The Phaser is a classic effect, created by ganged multiple all-pass filters to create "notches", or
sharp spikes in the frequency spectrum. The frequencies of these all-pass filters are usually
modulated by an LFO to create a sweeping sound.
Parameter Value Range Default Value Q-Link No.
Wet/Dry 0 (DRY) - 100 (WET) 100 (WET) Q10
Rate 0 - 100 10 Q11
Phaser 2
Parameter Value Range Default Value Q-Link No.
Wet/Dry 0 (DRY) - 100 (WET) 100 (WET) Q10
Rate 0 - 100 10 Q11
Phaser Sync
Parameter Value Range Default Value Q-Link No.
Wet/Dry 0 (DRY) - 100 (WET) 100 (WET) Q10
Rate 1 bar - 1/16 triplets 1/4 Q11
LP Filter Sweep
This effect is a filter with its cutoff frequency modulated by an LFO. Both high-pass and low-pass
filters are available.
Parameter Value Range Default Value Q-Link No.
Wet/Dry 0 (DRY) - 100 (WET) 80 Q9
Low Frequency 0 - 100 0 Q10
High Frequency 0 - 100 100 Q11
Resonance 0 - 100 33 Q12
Rate 0 - 100 10 Q5
LP Filter Sync
Parameter Value Range Default Value Q-Link No.
Wet/Dry 0 (DRY) - 100 (WET) 100 Q9
Low Frequency 0 - 100 0 Q10
High Frequency 0 - 100 100 Q11
Resonance 0 - 100 50 Q12
Rate 8 bars - 1/32 1/4 Q5