AKCP SP+ Series Introduction Manual

SPX+ Introduction Manual - updated until firmware 4997
- 55 -
SNMPv3
The SNMPv3 options can be found by scrolling down on the SNMP page.
This feature requires a separate license. You can read more details about the licensing below in this
manual.
Below we’ll give a quick description of each setting:
Level Authentication Encryption Description
No Authentication Username No Match Username (same as SNMP v1/v2c)
Authentication Only MD5 or SHA No Auth Based on Algorithms (check password)
Auth&Privacy MD5 or SHA Yes - DES Auth Algorithms and Encryption
Basically if you select No Authentication then the setup will be the same as with SNMP v1 and v2c
versions: authentication is only checked by unencrypted username.
Authentication Only will provide password protection but no encryption.
Authentication&Privacy provides encrypted username and password protection.

AKCP SP+ Series Specifications

General

Brand	AKCP
Model	SP+ Series
Category	Measuring Instruments
Language	English