SPX+ Introduction Manual - updated until firmware 4997
- 62 -
Password Checking and Security
You can turn on the password checking for the Web UI to ensure only authenticated users have
access to the unit. You can also specify to show all user names on the login page, or keep them
confidential.
After you enable the password checking, you’ll need to re-login.
If you don’t remember the Admin password, you can hold the unit’s reset button for 7-12 seconds to
be able to log in to the Web UI without a password.
Note 1: The passwords can only be set from the unit’s Web UI; this option is not available from APS.
Note 2: The default password is “public” for all access levels.
Web UI user access levels and permissions
Admin - full access to all settings, system and notification configurations
Viewer - read-only guest access for every page
User - full access to most settings except for those which are
the system-related such as network
In detail, the User access level provides these permissions in
addition to the Viewer level:
Allow modifying board/sensor settings
Allow add/modify/remove notifications
Allow add/modify/remove heartbeats
Allow open/close the door on the Handle Lock
Allow send configuration to Support
Allow change Graph settings
Allow change the Web UI language
To Next Page
Loading...
Need help?
General
