AKCP SP+ Series Introduction Manual

SPX+ Introduction Manual - updated until firmware 4997
- 92 -
Pulse Counter sensor
The pulse counter is available on the SP+ platform, as of firmware version 1.0.4967. It provides:
- accumulated pulse count
- flow conversion of the pulse count
It can measure up to 1000 pulses / sec (1 Kilohertz).
Normally this sensor should be used with some external sensor which outputs pulses.
Sensors that could work: basically any switch type sensor, and any custom sensor that could
generate a pulse signal. For example Wind speed sensor, Electricity meter etc.

AKCP SP+ Series Specifications

General

Brand	AKCP
Model	SP+ Series
Category	Measuring Instruments
Language	English