AKCP SP+ Series Introduction Manual

SPX+ Introduction Manual - updated until firmware 4997
- 72 -
Sensors page
On this page you can view all sensors connected to the unit per port, and per board.
Non-connected sensors will be also displayed, until you re-attach or manually remove them from the
configuration.
Select an expansion board from the menu list by clicking on it. You can then manage each board and
their sensors separately. Below is an example of a CCU board connected to a SPX+ unit:

AKCP SP+ Series Specifications

General

Brand	AKCP
Model	SP+ Series
Category	Measuring Instruments
Language	English