SPX+ Introduction Manual - updated until firmware 4997
- 7 -
Specifications
Dimension: 44 (W) x 46 (H) low profile design
Supports connection of: Modbus RTU, E-Sensor8, E-Opto16 and CCU Expansion modules through
optional EXP port and BEB port
Mounting: 0U Toolless rack mount, optional wall mount brackets, horizontal 1U mounting or DIN rail
brackets
Power: External 5V 2A Power Adapter, Input Voltage and Current ratings: 100V~240V - 0.22A,
Optional internal power supply
Status Indication: LED indication for power, network connectivity sensor online and threshold
Components: Manufactured using highly integrated, low power surface mount technology. All units
undergo a minimum 48 hour burn in cycle to detect in fact mortality.
Operating Environment: Temperature: Min. -35° C – Max. 70° C, Humidity: Min. 20% – Max. 80%
(Non-Condensing)
MTBF: 1,400,000 Hours based on field experience with sensorProbe units.
Base Unit: 4x Sensor Ports for connecting AKCP sensors or swing handle cabinet locks, 1x
Expansion Out Port (Optionally used for Modbus), 1x BEB port, 1x 10/100 Ethernet Port
Max Sensors: Maximum of 150 onlined sensors, including Expansion Units and virtual sensors (if
VPN is enabled - reduced to 36 on F4 units, 150 on F7 units)
To Next Page
Loading...
Need help?
General
