EasyManuals Logo

AKCP SP+ Series Introduction Manual

Default Icon
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #60 background imageLoading...
Page #60 background image
SPX+ Introduction Manual - updated until firmware 4997
- 60 -
If you don’t upload a certificate but enable HTTPS, a built-in certificate will be used. You’ll get a
browser warning upon opening the Web UI about an incorrect certificate. This is normal and you
should add it as an exception or proceed, depending on your browser:
Important: the default, built-in self-signed SSL certificate is only provided for user convenience so
that the HTTPS WebUI would work on the units out of the box. It WILL raise browser SSL security
warnings and is not meant to be used in production environments where higher security is mandatory.
To use SSL without warnings, you need to either add the units IP address to the exceptions, or
replace the certificate.

Other manuals for AKCP SP+ Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AKCP SP+ Series and is the answer not in the manual?

AKCP SP+ Series Specifications

General IconGeneral
BrandAKCP
ModelSP+ Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals