EasyManuals Logo

AKCP SP+ Series Introduction Manual

Default Icon
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #94 background imageLoading...
Page #94 background image
SPX+ Introduction Manual - updated until firmware 4997
- 94 -
In the Flow Sensor there is "Number of Pulse per Unit" in the config.
You can use this value to adjust the sensor reading to match the real-world value.
Dry contact will also work but only to count the pulses. If you want to test for the rate accuracy, you'd
have to test with something that can generate a wave signal, like using an oscilloscope to generate
wave form and plug it to the sensor port.
But the general idea of this sensor is that it will show the rate of received pulses and also count it.

Other manuals for AKCP SP+ Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AKCP SP+ Series and is the answer not in the manual?

AKCP SP+ Series Specifications

General IconGeneral
BrandAKCP
ModelSP+ Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals