For example, if you want to capture the jpg format image of the door phone with the IP address
192.168.1.104, you can enter http://192.168.1.104:8080/picture.jpg on the web browser.
You can set up the MJPEG video parameters in the MJPEG Video Parameters MJPEG Video Parameters section.
Video ResolutionVideo Resolution: Specify the image resolution, varying from the lowest CIF(352×288
pixels) to the highest 1080P(1920x1080 pixels).
Video Frame rate(fps)Video Frame rate(fps): Frames per second, refers to how many frames are displayed in
one second of video. The default frame rate is 30fps.
Video QualityVideo Quality: The video bitrate ranges from 50 to 90.
RTSP Stream MonitoringRTSP Stream Monitoring
You can use RTSP to watch a live video stream from other intercom devices on the device.
RTSP Basic SettingRTSP Basic Setting
You are required to set up the RTSP function on the device web Surveillance > RTSP > BasicSurveillance > RTSP > Basic
interface in terms of RTSP Authorization, authentication, password, etc before you can use the
function.
TipTip
To view a dynamic stream, use the URL http://device_IP:8080/video.cgi.
For capturing a screenshot, use the following URLs, with the image formats varying
accordingly:
http://device_IP:8080/picture.cgi
http://device_IP:8080/picture.jpg
http://device_IP:8080/jpeg.cgi
To Next Page
Loading...
