• Wait until construction and painting are finished before installing.
PREPARATION
The Existing Thermostat
1. Test the System
Verify that the heating and/or cooling system is operating properly before you try to install the new thermostat.
DO NOT test the system by shorting electric terminals at the furnace or air conditioner. This may damage the
thermostat.
2. Turn Power Off
• Turn all heating and cooling systems off. This can be done at the circuit breaker.
CAUTION: DO NOT REMOVE the existing thermostat until power has been turned off at the circuit breaker.
Once power to the heating AND cooling systems is off, follow these steps:
3. Remove Thermostat Cover
https://answers.alarm.com/Installation_and_Troubleshooting/Thermostats/Z-Wave_Thermostats/Alarm.com_Smart_Thermostat_(ADC-T2000)/Alarm.com_Smart_Thermostat_(ADC-T2000)_Installation_Guide
Updated: Sun, 15 Oct 2017 23:38:59 GMT
Powered by
4
To Next Page
Loading...
Need help?
General
