10 811
8. Using the optional ECS remote control or the Mobility app
Both the optional ECS remote control and the Mobility App can be used with the e-motion. However, for tech-
nical reasons, they cannot be used simultaneously with the control unit. Only one of these – either the control
unit, the ECS remote control or the Mobility app – can communicate with the two e-motion wheels at any one
time.
If you want to use the ECS remote control or the Mobility app, the control unit must be switched off beforehand
(see Chapter 9). The two e-motion wheels are then in standby mode and can be connected and activated using
the ECS remote control or the Mobility app with the ECS function enabled.
9. Switching off the control unit
The e-motion wheels go into standby mode if the control unit is switched off.
If the control unit is switched on, it can be used to switch off the two e-motion wheels or to set them to
standby mode.
• By briefly pressing the On/Off button [15], both e-motion wheels switch to freewheeling mode with
residual power assistance. Here, the control unit remains switched on.
• If the On/Off button [15] is pressed and held for longer than 2 seconds, both the control unit and the
two e-motion wheels are put into standby mode. All LEDs on the control unit go out. On both e-motion
wheels, the middle LED of the battery indicator briefly lights up every 10 seconds to signal standby mode.
• Depending on the time set in the wheels for automatic shutdown (see Chapter 13), the control unit
shuts down as well. It can then be switched on again by pressing the On/Off button [15]. The two
e-motion wheels are also automatically switched from standby mode to “ready for travel”.
When travelling, particularly when travelling by plane, the control unit and both e-motion
wheels must be shut down completely! For more information on air travel and flight mode,
see the M25 operating manual and the app.
To Next Page
Loading...
