6 87
Error in the system
In this regard, see the explanations in Chapter 12.4.
Fault due to Bluetooth devices
Check that all Bluetooth devices in your vicinity are switched off.
If this is the case and there is still no connection established between the drive unit and control unit despite
repeated attempts, please contact your specialist dealer.
5. Using the control unit (cruise mode)
If both e-motion wheels and the control unit are connected via Bluetooth, use of the e-motion can commence.
Note the following in this regard:
• In cruise mode, the e-motion can (from the user’s viewpoint) only move forwards; it cannot move backwards.
For this reason, always mount the e-motion wheels the right way round! They have already been provided
ex-works with stickers for left/right (direction of travel of the wheelchair). If the wheels are not fitted with
the correct orientation, there is a risk that the wheelchair will move backwards. There is a risk of injury.
• The control unit does not have any braking functions. The push rims [5] of the e-motion wheels control the
travel direction and braking of the wheelchair.
• Turning the speed dial [16] forwards sets the e-motion in motion. The further you move the speed dial in the
direction of travel, the faster your wheelchair will move.
• The speed dial [16] can be turned infinitely. However, once the maximum speed is reached, no further
increase in speed is possible.
• To reduce the speed, you need to turn the speed dial [16] against the direction of travel.
• To bring the wheelchair to a complete stop after switching off the drive, you need to brake it as usual using
the push rims.
• You can also activate cruise mode when the wheelchair has started to move. The current speed of the wheel-
chair is used as the starting speed for cruise mode, from which you can set the cruising speed to be faster or
slower by turning the speed dial [16] in or against the direction of travel.
16
To Next Page
Loading...
