EasyManua.ls Logo

Alcatel-Lucent 1830 PSS-4 - Page 357

Alcatel-Lucent 1830 PSS-4
722 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The two 4DPA4 card modes (FlexMux and DualTran) each have their own separate
firmware lines. When card mode is provisioned, the default version of the appropriate
firmware line is loaded automatically. Thus, FWUPGRADEPENDING may also apply to
a mismatch between the provisioned 4DPA4 card mode value and the current FPGA
contents.
Severity NA
Service affecting? No
Applicability 112SA1L, 112SCA1, 112SCX10, 112SX10L, 11DPE12E,
11DPM12, 11STAR1, 11STMM10, 11STGE12, 43SCX4,
43STA1P, 43STX4, 43STX4P, 4DPA2, 4DPA4, ALPHG, AHPHG,
AHPLG, ALPFGT, CWR8, CWR8-88, MESH4, MVAC, OPS,
OSCT, SVAC, WTOCM
Corrective Action
NOTICE
Service-disruption hazard
A cold reset, reseat, or replacement of a card is service impacting if the card is currently
carrying services. To determine if any services are currently carried over a card, perform
the procedure “Reseating a Card” (p. 3-19).
If
there are services currently carried over the card, it may be best to wait for a
maintenance window before resetting, replacing, or reseating the card.
At the end of each step wait to see if the fault clears. If not, continue with the next step.
...................................................................................................................................................................................................
1
To initiate a cold reset to download the recommended firmware version for the affected
pack, perform a cold reset of the card.
CLI config card card_type shelf slot reset cold
WEBUI Select the card, click the Reboot tab, select Cold Reboot >Submit.
Note: Refer to Caution at the beginning of this procedure.
...................................................................................................................................................................................................
2
Contact your next level of support.
Trouble-clearing procedures
FWUPGRADEPENDING
FWUPGRADEPENDING (Firmware upgrade pending)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
2-107
E ND OF STEPS
...................................................................................................................................................................................................

Table of Contents

Related product manuals