INVALIDEGRESS (Invalid or no egress port defined)
The INVALIDEGRESS condition is raised when a unidirectional AM2125A, AM2125B
or RA2P has an external topology provisioned on LineIn port, but no associated opposite
direction port is defined.
Severity Critical
Service affecting? Yes
Applicability AM2125A, AM2125B, RA2P
...................................................................................................................................................................................................
1
Check the topology between ingress and egress LD (if there is egress LD). Check the
external topology for the ingress LD line port. If the topology is missing, add the
topology and re-run the egress adjustment.
...................................................................................................................................................................................................
2
Ensure that Opposite Direction Port field is provisioned correctly for the egress LD
Lineout port.
CLI config interface
shelf/slot/port
oppDirection
WEBUI From the Equipment Tree, select the OPS card, and select the desired port (A
or B).
INVALIDTHRESHOLD
INVALIDTHRESHOLD
The OPS pack currently has an invalid switch threshold value provisioned. The threshold
must be greater than -30 dBm to clear the condition.
When a cross-connect is added for the first time, the INVALIDTHRESHOLD alarm is
raised for ports A and B, and then clears after a few seconds. If the XC is deleted and
reentered, then the INVALIDTHRESHOLD alarms is not raised.
Severity Minor
Service affecting? No
Trouble-clearing procedures
INVALIDEGRESS
INVALIDEGRESS (Invalid or no egress port defined)
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
2-118
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
E ND OF STEPS
...................................................................................................................................................................................................
To Next Page
Loading...
