...................................................................................................................................................................................................
9
Set up the software server information. Type each command line, and press Enter:
1.
config software server ip IP address
2.
config software server userid user ID
Enter your password when prompted.
3.
config software server root /path
4.
config software server detail
...................................................................................................................................................................................................
10
Set up the database server information. Type each command line, and press Enter:
1. Type
database server config.
2.
config database server ip IP Address, using the IP address where the
database is stored.
3.
config database userid, then enter your user ID and password when prompted.
4.
config database path directory with the path on the PC where the database is
saved.
5.
config database detail to verify your IP address, user ID, and path.
...................................................................................................................................................................................................
11
Upgrade the software. Type each command line, and press Enter:
1.
config software upgrade manual audit release directory on RFS
no backup enforced. (The release directory would be combined with the
Software server root parameter value to make the path on the Remote File Server
where the software release resides. See also the Alcatel-Lucent 1830 Photonic Service
Switch Release 36/32/16 (PSS-36/PSS-32/PSS-16) 3.6.0 Installation and System
Turn-up Guide.)
2.
config software upgrade manual load
3. Type config software upgrade manual activate.
The system will reboot.
...................................................................................................................................................................................................
12
Login to the NE.
Type
config software upgrade commit.
...................................................................................................................................................................................................
13
Telnet to the NE where the Equipment Controller is located.
...................................................................................................................................................................................................
14
Replace the Equipment Controller in the shelf. Wait a few minutes for the Equipment
Controller to initialize.
Supporting procedures
Replacing System Components
Replacing an Equipment Controller in a Nonredundant Shelf
....................................................................................................................................................................................................................................
....................................................................................................................................................................................................................................
3-48
1830 PSS-36/PSS–32/PSS-16/PSS-4
8DG60888CAAA Release 3.6.0 and 3.6.1
Issue 1 June 2011
To Next Page
Loading...
