Root Commands
7450 ESS OS Basic System Configuration Guide Page 121
ingress — Displays scheduler-name statistics applied on the ingress SAP.
egress — Displays scheduler-name statistics applied on the egress SAP.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without processing.
No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead of the
delta.
subscriber
Syntax subscriber sub-ident-string [scheduler scheduler-name] [ingress | egress] [interval seconds]
[repeat repeat] [absolute | rate]
Context monitor>qos>scheduler-stats
Description This command monitors cheduler statistics for a subscriber.
Parameters sub-ident-string — Specifies an existing subscriber a identification policy name.
scheduler scheduler-name — Specify an existing QoS scheduler policy name. Scheduler names are
configured in the config>qos>scheduler-policy>tier level context.
Values An existing scheduler-name in the form of a string up to 32 characters long composed of
printable, 7-bit ASCII characters. If the string contains special characters (#, $, spaces,
etc.), the entire string must be enclosed within double quotes.
ingress — Displays scheduler-name statistics applied on the ingress SAP.
egress — Displays scheduler-name statistics applied on the egress SAP.
interval seconds — Configures the interval for each display in seconds.
Default 11 seconds
Values 11 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without processing.
No calculations are performed on the delta or rate statistics.
To Next Page
Loading...
