Page 122 7450 ESS OS Basic System Configuration Guide
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead of the
delta.
router
Syntax router router-instance
Context monitor
Description This command enables the context to configure criteria to monitor statistical information for BGP, LDP,
MPLS, OSPF, RIP, and RSVP protocols.
Parameters router-instance — Specify the router name or service ID.
Values router-name: Base, management
service-id: 1 — 2147483647
Default Base
statistics
Syntax statistics [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>router>isis
Description This command displays statistical IS-IS traffic information at the configured interval until the configured
count is reached.
The first screen displays the current statistics related to the specified router statistics. The subsequent
statistical information listed for each interval is displayed as a delta to the previous display. When the
keyword rate is specified, the "rate per second" for each statistic is displayed instead of the delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters interval seconds — Configures the interval for each display in seconds.
Default 5 seconds
Values 3 — 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 — 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without processing.
No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed instead of the
delta.
To Next Page
Loading...
