Registering the telephone
8AL90386ENABed01
7
7.1 Registering the telephone on a system for the first time
For the mobile telephone to function, it must be registered on at least one Alcatel-Lucent Enterprise or
GAP system (registration operation). Your telephone has not yet been registered on any system if, when
first switched on, the display indicates: Auto install?
• Auto install?
• Confirm.
• Select a system (It is recommended that the first empty system is selected).
• Apply.
• Enter PARK code (Enter nothing if not mandatory).
• Apply.
• Enter access code (Enter nothing if not mandatory).
• Apply
• Power mode:
Select the power mode using the corresponding softkeys: Normal / 50 mW power (you
are advised not to select the 50 mW power mode unless required. The '50mW power
mode' is intended for hazardous sites such as nuclear plants where it is requested that
emissions do not exceed the maximum value.).
• Enhanced Security
• Yes / No
Call from encrypted system to un-encrypted system is accepted (yes) or rejected (no).
• Select 'Modic' mode:
o 8254 DECT Handset:
1. Select '8254 Modic' if you connect the handset to an OXO Connect
R4.0 and more, otherwise select '8232 Modic'.
2. Select '8232 Modic' if you connect the handset in IP-DECT mode.
o 8234 DECT Handset:
1. Select '8234 Modic' if you connect the handset to an OXO Connect
R4.0 and more, otherwise select '8232 Modic'.
2. Select '8232 Modic' if you connect the handset in IP-DECT mode.
The registration operation can last up to 2 minutes.
• If the operation has been done correctly (subscription accepted), the telephone is ready to be used
and the radio reception quality icon is displayed.
• If the registration operation has not been successful, the station proposes launching the subscription
again.
Utilization of the telephone in GAP mode can lead to functional limitations for which no claims will be
considered under the terms of the warranty.
During registration phase, to improve security and optimize registration in a multi-system environment, the
handset enforces a minimum signal strength level to accept to register to a base station. To achieve the
To Next Page
Loading...
