Alcatel-Lucent OmniSwitch 6570M - Hot-Swapping; Removing Power Supplies

Chassis and Power Supplies Power Supplies
OmniSwitch 6570M Hardware Users Guide December 2022 page 3-23
Note. The chassis does not provide an on/off switch. Connecting a the power supplies to a power source
will boot the switch.
Hot-Swapping / Removing Power Supplies
1 When removing a power supply, first disconnect the power cord from the power source. Once the
power cord is disconnected, pull the power cord out of the power supply housing.
2 Pressing the lock tab toward the center of the power supply, as shown, will free the power supply from
the chassis.
Lock Tab