26 June 2012 17
Configuration Manual
Alcatel-Lucent OmniTouch 8118/8128 WLAN Handset
Bands and Channels used by WiFi a-radio
802.11 b/g/n Channels
Defines which 802.11b/g/n channels to use. It is recommended to use the default value “1,6,11“.
If set to “All”, all channels are scanned for access points which decreases the WLAN
performance. Select “Advanced“ only if the channels shall be set in the parameter Advanced:
802.11 channels.
1 Select Network > Network A (B, C, or D).
2 In the 802.11 protocol drop-down list, select “802.11b/g/n“.
3 In the 802.11b/g/n channels drop-down list, select one of the following:
•All
• 1,6,11
• Advanced
Advanced: 802.11 Channels
Defines which 802.11 channels to use. Only used if the parameter in the 802.11b/g/n channels,
or 802.11a/n channels is set to “Advanced“.
Note: It is not possible to scan channels in 802.11b/g/n and 802.11a/n simultaneously.
1 Select Network > Network A (B, C, or D).
2 Enter channels to scan in a comma-separated list, for example 1,6,11 (the order has no
impact; 11,6,1 will give the same result).
6.3.5 Transmission Power
This is the transmission power the VoWiFi Handset will use when transmitting data to the
WLAN system. If “Automatic” (default) is used, the transmission power is adapted according to
802.11h, CCX or maximum possible.
1 Select Network > Network A (B, C, or D).
2 In the Transmission power drop-down list, select one of the following:
• Automatic
• 0 dBm
• 5 dBm
• 11 dBm
• 14 dBm
• 20 dBm (max)
Frequency band Channels
Non DFS 5.150 - 5.250 MHz,
5.725 - 5.845 MHz
36,40,44,48
149,153,157,161, 165
UNII-1 5.150 - 5.250 MHz 36,40,44,48
UNII-2 5.250 - 5.350 MHz 52,56,60,64
UNII-2 Extended 5.470 - 5.725 MHz 100, 104, 108, 112,116, 120, 124, 128, 132, 126,
140
UNII-3 5.825 - 5.835 MHz 149,153,157,161
To Next Page
Loading...
