26 June 2012 4
Configuration Manual
Alcatel-Lucent OmniTouch 8118/8128 WLAN Handset
2 Pre-Installation
Before installing VoWiFi Handsets in a VoWiFi system, make sure that all equipments are
available. It is recommended to set up chargers and charge the VoWiFi Handset batteries before
installation, and to have a number plan available for the VoWiFi Handsets. Also be sure that the
IP addressing plan is set up to support the amount of VoWiFi Handsets to be deployed.
We assume that the VoWiFi system is installed including some or all of the following
components (depending on system configuration):
• DHCP Server. A DHCP server allows devices to request and obtain an IP address from a
server which has a list of addresses available for assignment. If the WLAN does not have
access to a DHCP server, a list of static IP addresses is necessary.
• Portable Device Manager. The WinPDM is used for administration and programming of the
VoWiFi Handsets. All settings and updates are in this case done via the DP1 Desktop
Programmer cradle connected over USB.
2.1 VoWiFi System IP addresses
Complete the table below with the IP addresses, as a help when configuring the VoWiFi
Handsets.
Device IP address/Number/Port Required
IP-PBX If used
Subnet Mask
a
a. Only required if no DHCP is used, that is, static IP is used.
If used
Number plan N/A Yes
NTP Server address
b
b. Depending on system configuration
DNS Server address
a
VoIP settings
c
c. Gatekeeper IP address or SIP proxy IP address used to access the PBX.
Yes
Syslog server If used
TFTP server If used
Ekahau RTLS
d
d. The IP address and port to the location server.
If used
DHCP range
To Next Page
Loading...
