Alcatel XPS4010+ - Troubleshooting

TROUBLESHOOTING
Error Solution
The handset cannot be used. Make sure the power cord of the base
station is connected to a power source.
Make sure the batteries are charged and
inserted correctly.
Make sure the phone cables are properly
connected to the RJ-11 phone jacks.
Make sure the handset is connected to the
base station.
No dial tone. Make sure the power cord of the base
station is connected to a power source.
Make sure the phone cables are properly
connected.
Caller ID is not working. Contact your local phone service provider.
Wait for the handset to ring at least once
before picking up.
If the caller has disabled caller ID on their
phone, the phone number will not be
displayed.
Cannot reply to a call. Make sure your call return settings are
correct.
The battery depletes soon after
recharging.
Replace the batteries.
Cannot transfer a call. Make sure the handset number you have
entered is correct.
Make sure the target handset has been
registered to the same base station.
In standby mode, base Line
1~4 LED sparked
XPS-4010
+
has phone line detect function.
It will detect the phone line when the base
power on. In standby mode Line 1~4 LED
will off. Line LED sparkled means that the
base did not detect the phone line. Please
plug the PSTN phone line once again, then
power on the base.
38