116
Delayed Start/Cycle
(requires Clock to be set)
Allows you to programme the
boiler to start at a specified time
and day, weekly. It will provide heating using
the last saved settings for 24 hours, before
automatically shutting down again. This is
recommended for airing the vehicle over
winter if stored locally and hooked up to 230 V
power. Once Delayed Start/Cycle is enabled,
the system should be shut down by pressing
the Power button.
Clock
The clock must be set for
programmable functions to activate
at the correct time/day. If 12 V power
is lost, the clock will reset.
TIP: The optional Alde 3010-414 battery
backup uses two AA batteries and allows
the clock memory to be stored even if 12 V
power is lost.
Navigation Arrows
There are four screens in the Settings
Menu. The up/down arrows allow you
to navigate between them.
Night Mode
(requires Clock to be set)
Allows you to programme the boiler
to automatically change and select
settings at night. Set a start and stop time for
the night-time period. Set a day of the week,
or “All” for the same daily programme. You can
also define:
• Desired room temperature
• Invert Standby Screen
• Hot water ignore
• Temperature sensor (if discrete room
temperature sensors are connected)
• AC Quiet Mode (if Truma Aventa Comfort
air-conditioning unit is connected)
Day Mode
(requires Clock to be set)
Allows you to programme the boiler
to automatically change and select
settings during the day. Set a start and stop
time for the day-time period. Set a day of the
week, or “All” for the same daily programme.
You can also define:
• Desired room temperature
• Hot water ignore
Temperature Offset
Recalibrate the room temperature
displayed by the control panel in
0.5 °C increments. If an outdoor
temperature sensor is connected, this can also
be recalibrated.
Return
Return to the previous menu.
Prioritise
Select whether to prioritise gas
heating or electric heating, when
using both. Less demand will be
placed on the non-prioritised fuel.
TIP: If you’re hooked up to a site with a flat
rate 230 V supply, but still want the extra
performance from gas heating, prioritise
electric heating to save money on gas.
Button Sound
Bleep when a button is pressed.
Backlight
The brightness of the Standby
Screen can be adjusted from 1–3.
The display mode of the Standby
Screen can also be set.
Dark. The Standby Screen is deactivated,
the control panel may appear dormant
except for the power LED. Pressing the
screen will activate the Standby Screen
for 30 secs. Suited for use in dark/night-
time conditions.
ALDE HEATING OPERATING INSTRUCTIONS
To Next Page
Loading...
