3. Insert the bolt through the opposite side of the
guard (16) from where the hex nut sits, and then
through the clamp to the opposite side of the
guard (16). (Fig E)
4. Tighten using the supplied double ended
spanner (8mm end) (24). (Fig F)
Assembling the D Handle
1. Rest the line trimmer on the ground or a secure
surface such that it is resting on the fuel tank (6).
2. Remove the 4 x bolts, washers and nuts from the
D handle (12). (Fig G)
NOTE: Be careful not to lose these when
assembling.
3. Place the D handle (12) over the upper shaft
(11), choosing the most appropriate position for
the user along the shaft, and whilst holding the
clamp in position on the opposite side of the
D handle (12), insert the 4 x bolts through the
D handle (12) and through the clamp. (Fig H).
4. Rotate the D handle (12) 180 degrees to the
opposite side of the shaft, and then insert the
4 x nuts in the holes on the clamp. (Fig I)
5. Secure each bolt a couple of turns (or until they
are flush on the clamp but still loose) to hold the
clamp loosely into place. (Fig J)
E .
F .
G .
J .I .H .
General Assembly
To Next Page
Loading...
