ALDI 50750 - Manual Line Advancement and Maintenance; Advancing Line Manually; General Inspection and Repairs

26cc 2 Stroke Line Trimmer
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com
1800 909 909
MODEL: №. 50750 • 11/2015 • WLBC260X-2WNO
(toll free)
26
AFTER SALES SUPPORT
(toll free)
26cc 2 Stroke Line Trimmer
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. 50750 • 11/2015 • WLBC260X-2WNO
Advancing the line manually
WARNING: Always ensure the engine is turned off before
undertaking this task.
1. Push the bump knob (20) in while pulling on both lines to manually
advance the line.
2. Release the bump knob (20) and again pull on both lines to advance the
line further.
3. If the line still does not advance, remove the spool and check the lay of
the line. It may be twisted or trapped under over laying line.
Maintenance & Cleaning
General inspection
• Regularlycheckthatallthexingscrewsaretight.Theymayvibrateloose
over time.
• Alwayscheckwhenrststartingthemotorforeachusethatthecutting
head is not rotating under the power of the motor when the motor is
at idle.
• Donotperformanymaintenanceprocedureswiththemotorin
operation.
• Ensurethemotorhasstopped,andtheon/oswitch(10)isinthe
STOP position.
• Thesparkplugcover/capshouldberemovedfromthesparkplug.
• OnlyuseoriginalGardenlinereplacementcover/capwhencomponent
parts require replacement.
Repairs
Repairs beyond those described above, should only be undertaken by
trained personal. Should a malfunction occur do not use the unit any further
and do not attempt to repair it yourself. Contact Customer Service
on 1800 909 909, or have the unit repaired by an approved Service Agent.
79
Advancing the line