Removing the Spool and Line Assembly
NOTE: Always ensure the engine is turned off before
undertaking this assembly.
1. Using the supplied spool tool (25), insert the raised
tabs on the spool tool (25) into the notches on the
bump knob (20), and whilst holding the spool and
line assembly (21) with the other hand, loosen the
bump knob (20) in an anti-clockwise direction
until it can be removed. (Fig O)
2. Whilst holding the spool and line assembly (21)
with the other hand, remove the spool and line
assembly (21) from the spindle. (Fig P)
If replacing with a new spool and line assembly,
follow the directions in the “Fitting of the Spool
and Line” section.
If replacing just the spool line on the supplied
spool and line assembly, refer to the instructions
following this section.
Changing the line only on the Spool
and Line Assembly
NOTE: Always ensure the engine is turned off before
undertaking this assembly.
NOTE: The spool and line assembly (21) supplied
with this product requires 1 length of 2mm diameter
nylon cutting line with a length NOT EXCEEDING 4
metres long. Do NOT attempt to fit larger diameter
line or length longer than 4 metres as this will
prevent the bump feed to operate correctly.
1. Whilst holding the removed spool and line
assembly (21) from the line trimmer (Note: the
bump knob (20) has already been removed),
slightly rotate the spool cover to the left or right to
release / open the assembly cover. (Fig Q/R)
Ensure the lines protruding from the eyelets are
carefully pulled out when you remove the inner if
there is any line left on the spool. (fig S). (Fig S)
P.
R.
S .
Q.
LOCK
OPEN
General Assembly
To Next Page
Loading...
