Operation
Starting the Line Trimmer
Choke control
Start position (choke closed).
Run position (choke open).
1. Press the On/Off switch (10) to the ‘On’ position
marked with an “I”. (Fig AE)
2. Move the choke lever (red lever) (17) upwards
to the start position (cold start). (Fig AF)
NOTE: This is not required if the engine is already warm.
3. Push the priming bulb (18) 6-10 times, until the primer bulb fills with the
fuel/oil mixture. (Fig AG)
4. Pull the recoil starter (2) until you hear the engine starting or trying to
start. (Fig AH) (Under full choke it may only run for 1 or 2 seconds).
Push the choke (red lever) (17) half way down and allow the motor to
warm up. Restart if the motor stops.
5. Once the engine is fully warm ensure the choke
lever (red lever) (17) is down fully to the run position (warm start).
6. This line trimmer is fitted with a centrifugal clutch. When the line trimmer
engine is running at idle, the spool and line will not rotate.
NOTE: When the line trimmer engine is at idle, if the spool and line is
rotating and driven by the idle engine, the line trimmer must be turned
off and the line trimmer taken to an authorised Service Agent for review.
Do not use the line trimmer if the spool and line is engaged when the
engine is on idle.
AE.
AH.A F. AG.
To Next Page
Loading...
