NOTE: When removing the spool, there is a spring located in between the
spool and the spool cover. Be careful not to lose this. (Fig T)
2. Remove any remaining line in the spool.
3. Prior to fitting the line into the spool the line needs to be prepared.
Take a 4 metre length of 2mm line and halve it.
Inspect each end of each line and ensure the
line has no burrs from being cut.
4. Fold the full length of line in half, (Fig U) and
place the half way mark of the line into the
notch in the spool (Fig. V)
5. Wrap the line around the inside of the spool
(following the directional arrow on the
underside of the spool as indicated by the
“WIND CORD” and arrow). Ensure the line is
wrapped tightly and neatly, and each line
remains in the designated channel and does
not cross over into the other. (Fig. W)
6. When there is approximately 150mm of line left,
lock one of the lines into one of the line location
notches in the spool head and the other into
the opposing notch (Fig. X).
T.
X.W.V.
U.
General Assembly
To Next Page
Loading...
