7. With the spool and line ready to re-assemble,
place the spring into the groove on the top
of the spool head (Fig Y), and place the spool
cover over the top. As you insert the spool,
thread the lines through the eyelets (Fig. Z)
8. The spool will need to be rotated slightly so
as to locate into the housing. Push firmly to
ensure the inner spool of line is fully inserted
into the spool cover. This may also unclip the
line from the inner notches.
9. When the cover is in place pull on the lines to
ensure the line is free from the inner notches.
(Fig AA)
NOTE: If the lines do not pull free from the
notches, the line will not advance when bumped.
If you are in doubt, refer to the section “Advancing
the line manually” on page 26 and ensure the line
is feeding.
RECHECK and ensure the outer cover is fully
clipped in place.
To clip the inner spool into the outer spool cover,
push firmly on the inner spool into the spool
cover and turn the inner spool until it locks
into the outer spool cover. This will assist when
mounting the spool and line assembly (21) on to
the line trimmer.
To re-install the spool and line assembly (21), refer to “Fitting of the Spool
and Line Assembly” instructions on page 14.
Y.
AA.
Z.
General Assembly
To Next Page
Loading...
