45
Cleaning and maintenance
− Do not use a high-pressure cleaner to clean the table saw.
− Ensure that no water or other liquids get into the housing.
Risk of damage!
Improper cleaning or irregular maintenance could lead to damage to
the table saw.
− Keep all safety devices, air vents and the motor housing free of
dirt and dust as far as possible.
− Clean the table saw after you use it each time.
− To avoid damaging the surfaces do not use aggressive cleaning
products, brushes with metal or nylon bristles and sharp or
metallic cleaning implements such as knives, hard spatulas or
similar.
Cleaning the table saw
1. Set the operating switch (
43
) to position “0”.
2. The power plug must be pulled out of the socket outlet before
you start any cleaning work.
3. Allow the table saw to cool down completely.
4. Do not wash the table saw and do not spray it down with a water
jet either.
5. Ensure that no water gets into the housing.
6. Never use any aggressive cleaning products, sharp or metallic
cleaning implements such as knives, hard spatulas or similar.
These could damage the surfaces.
7. Clean the bench-type circular immediately after you use it each
time.
8. Keep the safety devices free of dirt and dust as far as possible.
Layout_F_TS_2000_1_UK_SPK7.indd 45Layout_F_TS_2000_1_UK_SPK7.indd 45 23.06.2020 14:29:3723.06.2020 14:29:37
To Next Page
Loading...
Need help?
General
