47
Cleaning and maintenance
Risk of damage
The ingress of water into the housing could cause a short-circuit.
• Never immerse the table saw in water.
• Ensure that no water gets into the housing.
Correct and regular care is not only important for safe use, it will also
contribute to a longer service life for your table saw.
Replacing the power cable
Risk of electric shock!
If the power cable is damaged or not fitted properly, there is a risk of
electric shock.
- If the power cable for this equipment is damaged, it must be
replaced by the manufacturer or OEM (Original equipment
manufacturer) after-sales service or by similarly trained
personnel to prevent hazards.
Inspecting the table saw
Inspect the table saw regularly to check its condition.
Among other things, check whether:
− the operating switch (
43
) is undamaged,
− the accessories are in perfect condition,
− the power cable and the power plug are undamaged,
- the ventilation slots are clear and clean. Use a soft brush or a
brush with bristles to clean them if necessary.
If you find any damage, you must arrange for it to be rectified
by a service center to prevent hazards.
Layout_F_TS_2000_1_UK_SPK7.indd 47Layout_F_TS_2000_1_UK_SPK7.indd 47 23.06.2020 14:29:3723.06.2020 14:29:37
To Next Page
Loading...
