44
Cleaning and maintenance
14. Hold the saw blade securely using the saw blade wrench and
turn the hexagon screw until it is tight using the ring wrench.
15. Fit the splitter, table insert and saw blade guard as described in
the section “Fitting/adjusting the splitter”.
Cleaning and maintenance
Risk of injury!
There is a risk of serious injuries if the table saw is handled
improperly.
• Switch off the table saw and pull the power plug out of the socket
before you start any cleaning work.
• Wear suitable protective gloves when carrying out work on the
table saw.
Risk of burns!
Since the saw blade becomes hot during operation, you may burn
yourself.
− Therefore, allow the saw blade to cool down completely every
time before you start any cleaning or maintenance work.
Risk of short-circuiting!
The ingress of water or other liquids into the housing could cause a
short-circuit.
− The power plug must always be pulled out of the socket outlet
before starting any cleaning or maintenance work.
− Never immerse the table saw in water or other liquids.
Layout_F_TS_2000_1_UK_SPK7.indd 44Layout_F_TS_2000_1_UK_SPK7.indd 44 23.06.2020 14:29:3723.06.2020 14:29:37
To Next Page
Loading...
Need help?
General
