ALDI FERREX F-TS 2000-1 User Manual

53
Troubleshooting guide
*labelled with: Cd = cadmium, Hg = mercury, Pb = lead
The reprinting or reproduction by any other means, in whole or in
part, of documentation and papers accompanying the products is
strictly subject to the express consent of iSC GmbH.
Subject to technical changes
Troubleshooting guide
Problem Possible cause Solution
The motor of the
table saw does
not start.
The power plug is not
connected to the supply.
The building fuse or the RCCB
has tripped.
The motor overload cut-out
has tripped because the
motor is overloaded or has
overheated.
Insert the power plug.
Check the power cable and,
if applicable, the extension
cable for damage. Replace
the fuse and/or switch it on
again (circuit breaker).
Allow the table saw to cool
for 15-20 minutes.
Poor sawing
performance, the
saw blade does
not run smoothly
and/or a lot of
dust is produced
when sawing.
The saw blade is blunt. Replace the saw blade with
a new one.
A lot of sparks
are generated on
the motor.
The carbon brushes are
defective.
Have the table saw checked
by a service center.
Layout_F_TS_2000_1_UK_SPK7.indd 53Layout_F_TS_2000_1_UK_SPK7.indd 53 23.06.2020 14:29:3823.06.2020 14:29:38

ALDI FERREX F-TS 2000-1 Specifications

General

Brand	ALDI
Model	FERREX F-TS 2000-1
Category	Saw
Language	English