27
AFTER SALES SUPPORT
Sewing
GB
0333 32 13 106
IRE
1 800 992508
www.medion.co.uk
GB IRE
Reverse stitching/ pattern completion
Use reverse stitches to reinforce the start and the end of a seam.
Reverse stitching with straight stitches, zigzag stitches and
buttonholes
Press and hold down the reverse button
8
.
Press the foot pedal – the more pressure you apply to the foot pedal,
the faster the machine runs.
When you want to change back to forward stitching, simply release
the reverse lever
8
.
Pattern completion for decorative stitches
Press the reverse
8
button.
The machine automatically makes four small stitches to fi nish off the
pattern.
The position of these closing stitches is always exactly where the
seam ends.
Removing fabric from the sewing machine
When you fi nish sewing, make sure that the needle is at its highest
position. To remove the fabric, raise the presser foot
26
and pull out
the fabric towards the rear.
Changing the sewing direction
To change the sewing direction at the corner of the material, proceed as
follows:
Stop the machine and turn the hand wheel
24
towards you until
the needle is in the fabric.
Raise the presser foot
26
.
Turn the fabric around the needle to change the direction as desired.
Lower the presser foot
26
and continue sewing.
TIP
You can also set the needle to the bottom position. To do this, proceed
as described in the section „Setting the needle end position“ on page
25.
Cutting the thread
Cut the thread with the thread cutter
15
on the back of the sewing
machine or with a pair of scissors. Leave around 15 cm of the thread
hanging behind the eye of the needle.
Built-in
thread cutter
15694 EN ALDI UK_IRE Content MSN 5005 3188 final.indd 2715694 EN ALDI UK_IRE Content MSN 5005 3188 final.indd 27 12.05.2016 07:00:2412.05.2016 07:00:24
To Next Page
Loading...
