ALDI md15694 - Maintenance and Cleaning - Component Care; Presser Foot Management; General Machine Maintenance; Housing and Pedal Cleaning

41
AFTER SALES SUPPORT
Maintenance and cleaning
GB
0333 32 13 106
IRE
1 800 992508
www.medion.co.uk
GB IRE
Removing and fi tting the presser foot
Removing
 Turn the hand wheel
26
towards you until the needle has reached
its top position.
 Raise the presser foot by pushing up the presser foot lever
20
.
 If you press the presser foot release lever
30
behind the presser foot
holder
29
, the presser foot drops out.
Fitting
 Attach the presser foot so that the pin on the foot is directly under
the groove of the foot holder. Lower the presser foot lever
20
.
 Now push the presser foot release lever upwards. The presser foot
automatically clicks into place.
Removing and fi tting the presser foot holder
The presser foot holder does not need to be removed unless you want
to darn or embroider, or make space to clean the fabric feeder
33
.
Removing
 Move the needle to its top position by turning the hand wheel
26
towards you and raise the presser foot lever
19
.
 Remove the foot from the presser foot holder and undo the presser
foot holder screw
31
using the screwdriver provided.
Fitting
 Move the needle to its top position by turning the hand wheel
26
towards you and raise the presser foot lever
19
.
 When you fi t the presser foot holder, push it upwards as far as
possible and tighten the presser foot holder screw using the
screwdriver provided.
Maintaining the sewing machine
The sewing machine is a sensitive mechanical product and requires
regular maintenance to ensure it always functions perfectly.
You can carry out this maintenance yourself.
Care involves mainly: cleaning and oiling.
Only use high-quality sewing machine oils. Other oils are not suitable.
Please note that after oiling, there may be oil residue in the machine. To
get rid of this residue, sew a few stitches on a swatch or scrap of fabric.
This will stop your actual fabric from getting soiled.
Cleaning the housing and foot pedal
Before cleaning, pull the plug out of the mains socket.
Use a dry, soft cloth to clean the housing and foot pedal. Avoid the
use of chemical solutions and cleaning products because these may
damage the appliance surface and/or markings.
15694 EN ALDI UK_IRE Content MSN 5005 3188 final.indd 4115694 EN ALDI UK_IRE Content MSN 5005 3188 final.indd 41 12.05.2016 07:00:2812.05.2016 07:00:28