ALDI md15694 - Faults and Troubleshooting - Specific Issues; Seam Puckering and Thread Loops; Irregular Feed and Machine Stoppage; Acoustic and Display Messages

44
AFTER SALES SUPPORT
Faults
GB IRE
GB
0333 32 13 106
IRE
1 800 992508
www.medion.co.uk
Malfunction Cause Page
Puckering or gathering of seam Upper thread tension too high Page 24
Machine threaded incorrectly Page 19
Needle too large for the fabric Page 45
Thread makes loops Thread tension not adjusted Page 24
Upper thread not threaded correctly
and/or lower thread not wound onto
bobbin correctly
Page 18
Thread thickness not suitable for the
fabric
Page 45
Fabric feed irregular Stitch length is "0" Page 28
Thread ends in shuttle track Page 42
Machine does not run Sewing machine not connected correctly
or there is no power from the socket
Page 15
Thread ends in shuttle track Page 42
Helpful messages
Acoustic signals
Acoustic signal Reason
1 x beep Normal operation
2 x beeps Invalid operation
3 x beeps Invalid machine settings
4 x beeps The machine is jammed
Useful displays
Display Reason Solution
The bobbin spindle is still in position for
winding.
Press the bobbin spindle left.
The buttonhole lever is not lowered or
raised.
Lower the buttonhole lever.
Push the buttonhole lever upwards.
The machine was stopped because
thread or fabric remnants are blocking
the mechanism.
Switch off the machine and remove the thread or
fabric remnants.
15694 EN ALDI UK_IRE Content MSN 5005 3188 final.indd 4415694 EN ALDI UK_IRE Content MSN 5005 3188 final.indd 44 12.05.2016 07:00:2912.05.2016 07:00:29