g) Use the power tool, accessories and fitted tools etc. in accordance
with these instructions, taking into account the working con-
ditions and the work to be performed.
Use of the power tool for
operations different from those intended could result in a hazardous
situation.
Service
a) Have your power tool serviced by a qualified repair person using
only identical replacement parts.
This will ensure that the safety of
the power tool is maintained.
Safety instructions for the saw
− For your own safety, only operate the saw after you have read the safety
instructions.
− Hold the saw by the insulated gripping surfaces, when performing
an operation where the fitted tool may contact hidden wiring. Cutting
accessory contacting a “live” wire may make exposed metal parts of the
power tool “live” and could give the operator an electric shock.
− Only use sharp saw blades in proper condition. Immediately replace any
cracked, bent or dull saw blades.
− Adapt fitted tools and the stroke rate to the material. Ensure an even feed
motion.
− Make sure that the permissible stroke rate of the fitted tool is at least as
high as the maximum number specified on the saw. Accessories that
move faster than permissible may break and be projected.
− Only operate the saw if the saw shoe is mounted. When working, the saw
shoe must always be located on the work piece.
− Only run the saw up to the work piece once it has been switched on.
− Never process material containing asbestos. Use a protective mask and
dust extractor for other fibrous material.
− When using machines outdoors, they must be connected via a residual
current device (RCD). Extension cords and plugs must be approved for
outdoor use.
− Do not slow down the saw blade by applying side pressure.
− Use clamping devices to secure the work piece and prevent slippage.
− Always run the cable backwards away from where you are working.
To Next Page
Loading...
Need help?
General
