Cleaning and maintenance
WARNING!
Risk of injury!
Improperly handling the saw may result in injury.
− Pull the mains plug out of the socket before performing work on the saw.
− Let the saw cool off completely before performing work on the saw.
− Remove the saw blade before performing work on the saw and wear
protective gloves to prevent cut injuries.
− Wear protective goggles when cleaning.
− After performing any cleaning and maintenance work, mount all protec-
tive devices, to the extent present, properly and safely. Never use the saw
without protective devices.
NOTICE!
Risk of short circuit!
Water that has penetrated the housing may cause a short circuit.
− Never submerge the saw in water or other liquids.
− Make sure that no water penetrates the housing.
NOTICE!
Risk of damage!
Improperly cleaning may lead to damage.
− Do not use any aggressive cleaners, brushes with metal or nylon bristles
or sharp or metallic cleaning utensils such as knives, hard scrapers and
the like. They could damage the surfaces.
− Never use a solvent to clean plastic parts.
Cleaning the saw
− Clean the housing
4
with a soft cloth or paintbrush.
− Use a soft brush to remove any dust that has collected from the device openings.
− Remove dust or chips by blowing them out with compressed air.
To Next Page
Loading...
Need help?
General
