First use
WARNING!
Risk of injury!
Handling the saw improperly may result in severe injury.
− Before working on the saw, pull the mains plug out of the socket.
Checking the saw and pack contents
1. Open the package and pull the transport case
14
out.
2. Open the transport case and carefully take the saw and accessories out.
3. Check to make sure that the delivery is complete (see fig. A).
4. Check whether the saw or the individual parts exhibit damages. If this is the case,
do not use the saw. Contact the manufacturer at the service address specified on
the warranty card.
Inserting the saw blade
WARNING!
Risk of injury!
Improperly changing the saw blades can result in cut injuries.
− Wear protective gloves when changing the saw blade.
NOTICE!
Risk of damage!
Using improper saw blades could damage the saw.
– When changing the saw blade, make sure that you only use saw
blades with the adjacent holding profile.
1. Make sure that the mains plug
9
has been pulled.
2. Open the saw blade holder
11
by turning the locking mechanism
2
counter-
clockwise up to the stop and holding it in this position (see fig. B).
3. Insert the saw blade
1
up to the stop point in the saw blade holder.
To Next Page
Loading...
Need help?
General
