Continuous operation
Activating continuous operation
1. Push the On/Off switch
10
up to the stop point.
2. Push the locking switch
7
into the handle
8
.
3. Release the On/Off switch again.
The saw will now run continuously with the preset stroke rate (see chapter
“Setting the stroke rate”).
Deactivating continuous operation
1. Push the On/Off switch
10
again.
The locking switch
7
will release.
2. Release the On/Off switch and wait until the saw has come to a complete stop.
Make sure that you deactivate continuous operation before you pull the
mains plug so that the saw does not immediately switch on again the
next time you connect it with the power supply.
Sawing
NOTICE!
Risk of damage!
Improper handling of the saw may result in damage.
− Secure your work pieces with a clamping device before you start sawing.
− When performing work, consider the maximum cutting depth of 180mm.
− After working for a prolonged period at a low stroke rate, let the saw
cool off by running it without a load at maximum stroke rate for approx.
3minutes. Make sure that the saw blade is not able to come in contact
with anything.
To find the best stroke rate and suitable angle for the saw shoe
12
, it is
recommended that you first perform some test cuts on a waste piece.
1. Switch the saw on and guide it towards the work piece you intend to cut.
2. Place the saw shoe on the work piece surface and saw through the material by
applying uniform contact pressure or feed.
To Next Page
Loading...
Need help?
General
