GB
IRE
0044 151 649 1500
0044 1890 946 244
GB IRE
− Wear personal protective gear when using the table saw. This may
include:
• Ear protection to reduce the risk of becoming hard of hearing;
• Eye protection;
• Respiratory protection to reduce the risk of inhaling dust that is
hazardous to health;
• Gloves when handling saw blades and rough materials. It is
recommended to store the saw blades in a container to prevent injury.
− Connect the table saw to a suitable dust extractor when cutting wood.
− Promptly replace a worn or damaged table insert.
− Use a push stick or a push block to safely push the work piece through the
saw blade.
− Always keep the push stick or the push block by the machine when not in
use.
− Do not try to cut rebates or grooves with the table saw without fitting a
suitable protective device, e.g. a tunnel-type device, over the saw table.
− Do not use the table saw to cut slots (a groove ending in the work piece).
− Only use saw blades whose maximum permissible speed is not less than
the maximum spindle speed of the table saw and suitable for the material
you intend to cut.
− Only use the transport fixtures for transport; never use the protective
fixtures for handling or transport.
− During transport, always cover the top part of the saw blade, for example,
with the saw blade guard.
WARNING!
Risk of electric shock!
A faulty electrical installation or excessive mains voltage may result in an electric
shock.
− Only connect the table saw if the mains voltage of the socket corresponds
to the specification on the rating plate.
− Only connect the table saw to an easily accessible socket so that you can
quickly disconnect the table saw from the power supply in the event of a
fault.
To Next Page
Loading...
Need help?
General
