GB IRE
GB
IRE
0044 151 649 1500
0044 1890 946 244
Troubleshooting
Problem Possible cause Solution
The motor of the
table saw is not
running.
The mains plug has not
been inserted.
Insert the mains plug.
The house fuse or residual
current protection switch
has triggered.
Check the mains cord and, if
applicable, the extension cord
for damage.
Replace the fuse or switch it
back on (circuit breaker).
The motor overload protec-
tion has triggered because
the motor is overloaded or
overheated.
Let the table saw cool off for
15–20 minutes.
Insufficient cutting
power, the saw
blade does not run
smoothly and/or
a large amount of
dust is produced
while sawing.
The saw blade is dull. Replace the saw blade with a
new one.
The motor produc-
es a large amount
of sparks.
The carbon brushes are
defective.
Have the table saw checked by
a qualified workshop.
To Next Page
Loading...
Need help?
General
