GB IRE
GB
IRE
0044 151 649 1500
0044 1890 946 244
Maintenance and care
WARNING!
Risk of injury!
Improperly handling the table saw poses a risk of serious injury.
− Before maintenance, switch the table saw off and pull the mains plug out
of the socket.
− Wear suitable protective gloves when working on the table saw.
− There are no parts that can be repaired by the user inside this table saw.
Never attempt to repair the table saw yourself. Always contact a qualified
workshop for this.
NOTICE!
Risk of damage
Water that has penetrated the housing may cause a short circuit.
− Never immerse the table saw in water.
− Make sure that no water penetrates the housing.
Proper, regular care is not only important for safe use, but also helps
to extend the service life of the table saw.
Replacing the carbon brushes
The carbon brushes may only be replaced by a specialist workshop or qualified
specialist personnel.
Replacing the connector cord
If the mains connection line of the table saw is damaged, it must be replaced by the
manufacturer, its after sales support or a similarly qualified person in order to prevent
risks.
To Next Page
Loading...
Need help?
General
