GB
IRE
0044 151 649 1500
0044 1890 946 244
GB IRE
Cleaning
WARNING!
Risk of injury!
Improperly handling the table saw poses a risk of serious injury.
− Before cleaning, switch the table saw off and pull the mains plug out of
the socket.
− Wear suitable protective gloves when working on the table saw.
WARNING!
Burn hazard!
The saw blade may become hot during operation, you could burn yourself on it.
− Always let the saw blade cool off completely before cleaning.
NOTICE!
Risk of damage
Water that has penetrated the housing may cause a short circuit, improper
cleaning could damage the table saw.
− Do not wash the table saw and also do not spray it off with a water jet.
− Make sure that no water penetrates the housing.
− Do not use any aggressive cleaners, sharp or metallic cleaning utensils
such as knives, hard scrapers and the like. They could damage the
surfaces.
− Clean the table saw directly after each use.
− Keep the protective devices as free of dust and dirt as possible.
− Rub the table saw off with a clean cloth or blow it off with low-pressure
compressed air.
Wear protective goggles when using compressed air.
− Use a damp cloth and a small amount of soft soap if it is heavily soiled.
To Next Page
Loading...
