3
Installation:
:
:
:
:
Operation:
:
:
:
:
Maintenance:
:
:
:
:
3. Safety precautions
- Always read the technical data thoroughly
(see page 21).
- Always release compressed air after use.
Never touch the clip assembly or the actuator
piston rod if the actuator is supplied with
compressed air.
Never touch the valve or the pipelines when
processing hot liquids or when sterilizing.
- Never dismantle the valve with valve and
pipelines under pressure.
- Never dismantle the valve when it is hot.
- Always read the technical data thoroughly
(see page 21).
- Always release compressed air after use.
Never touch the valve or the pipelines when
processing hot liquids or when sterilizing.
Never touch the clip assembly or the actuator
piston rod if the actuator is supplied with
compressed air.
Always handle lye and acid with great care.
- Always read the technical data thoroughly
(see page 21).
- Always release compressed air after use.
- Never service the valve when it is hot.
- Never service the valve with valve and
pipelines under pressure.
Never stick your fingers through the valve ports if
the actuator is supplied with compressed air.
Never touch the clip assembly or the actuator
piston rod if the actuator is supplied with
compressed air.
All warnings in the manual are summarized on this
page.
Pay special attention to the instructions below so that
severe personal injury and/or damage to the valve are
avoided.
Safety
To Next Page
Loading...
Need help?
General
