4.4 Options
The operational functionality of the ThinkTop can be further customized with the following options.
Burst clean
If you want to enable the burst clean feature to optimize the cleaning process in a double seat valve
application.
Y
ou can enable this option both before or after setup.
Navigate the menu until the LED 4 (Seat valve) flashes by pressing SELECT four times, and then
press ENTER to toggle the option ON.
PMO feedback
If you want to optimize the electrical feedbacks for PMO conformity.
You can enable this option both before or after setup.
Navigate the menu until the LED 8 (Rotary valve) flashes by pressing SELECT five times, and then
press ENTER to toggle the option ON.
Key lock
If you want to tamper proof the control board, the SELECT button can be locked by holding the
ENTER button for 7s until the 4 first LEDs has come ON.
Note: The SELECT button is unlocked by repeating the process.
Setup reset
Use the following process to reset the ThinkTop to factory default.
Hold both ENTER and SELECT for 7 seconds, until all LED’s in the array are turned off.
The ThinkTop flashes green when reset.
Check setup status
Use the following procedure to check how the ThinkTop was setup.
Press ENTER. The setup status is presented on the LED array.
The LEDs indicate the type of setup that was used and the type of valve the control unit expects to be
mounted on.
Note: The Live setup status is presented by LED 1 and 2 together.
200000549-1-EN-GB 23
Setup 4 EN
www.sks-online.com
www.sks-webshop.com
To Next Page
Loading...
Need help?
General
