3 Installation
This chapter covers the installation of any ThinkTop variant within the V50 and V70 families on any
Alfa Laval rising stem valve.
T
ools
To carry out the installation, you need the following tools:
Hex key Adjustable spanner or flat wrenches
(additional 12, 15 and 17 for Seat lift sensor installation)
When using wire end ferrules for ease of electrical installation it is recommended to choose ferrules
with a barrel length of 10mm to ensure full engagement in the terminals.
200000549-1-EN-GB 9
EN
www.sks-online.com
www.sks-webshop.com
To Next Page
Loading...
Need help?
General
